· Circuit board. (gray area) on the is the input cable. Automatically identifies the sensor switch (NPN, PNP, or second-weave switch) type. Use "jumpers" to select the output signal type (PNP,NPN, repeater) through the relay circuit (green area) to avoid voltage drop, and then use "jumpers" to define whether to convert to NO/NC series or parallel input and output (orange area). When the selection is completed, the output signal (blue/yellow area) is connected to the cable.
Power supply: 24Vdc (± 10%)
· Input: Up to 6 PNP, NPN or dry contact (NO or NC)(gray area) selectable by jumper.
· Output: 1 to 6 PNP, NPN or dry contact (NO) outputs (yellow area) selectable by jumper (red area).